Ricoh V-C3 D081 Field Service Manual page 112

2. Installation
2
5. Discard the short bracket [A] and screws [B] ( x2).
6. Re-install large bracket [C] ( x6).
• You must fasten the flat-head screw at [A].
• Tighten the screws in the order above marked by the numbers 1 to 5. This ensures precise
alignment of the bracket.
7. Set the harness clamp (standoff) [A] on the large bracket.
8. Connect the small end of the accessory USB cable [B] to the slot unit (
110
x1).