Ricoh V-C3 D081 Field Service Manual page 743

Application selection error 1
An application did not start after pressing the appropriate key on the operation
panel.
SC997 B
• Software bug (change the firmware for the application that failed)
• A RAM or DIMM option required by the application is not installed or not
Application selection error 2
Register processing did not execute for an application within 60 s after the machine
was switched on. No applications start correctly, and all end abnormally.
SC998 D
• Software bug (change the firmware for the application that failed)
• A RAM or DIMM option required by the application is not installed or not
Additional SC Codes Printed in SMC Reports
These codes are also used in the SMC report. Codes that have the same number in this series are identified
by an additional 4-digit hexadecimal number.
SC No. Symptom
SC853 D
SC854 D
SC855 D
SC856 D
SC870 B
installed correctly.
installed correctly.
IEEE802 11b card startup error
Not used.
IEEE802 11b card access error
Not used.
IEEE802 11b card error
Not used.
IEEE802 11b card connection board error
Not used.
Address book data error
Possible Cause
Service Call Tables
GW
3
GW
165