Guidelines - Polycom RMX 1500 Administrator's Manual

Guidelines

• Multiple Services system mode is a purchasable option and it is
enabled in the MCU license.
• Multiple Services system mode is enabled when the system
configuration flag MULTIPLE_SERVICES is added and set to YES.
The MULTIPLE_SERVICE System Flag cannot be set to YES when IPv6
Addressing is enabled.
• In version 7.2, when configuring Multiple Networks on the RMX 2000,
the RMX2000_RTM_LAN flag must be set to YES in addition to the
MULTIPLE_NETWORKS=YES flag
• This option is supported with MPM+ and MPMx media cards.
• Multiple Network Services are supported in MCUs with at least
1024MB memory only. MCU units with memory of 512MB support
only one IP Network Service.
• Multiple Network Services are NOT supported with Microsoft ICE
Environments.
• Only IPv4 is supported for the definition of Multiple Network
Services.
• In RMX 1500, up to two Network Services, one per LAN port, can be
associated with each Media card.
In RMX 2000/4000 a media card can be associated with only one
Network Service.
• On RMX 2000/4000, RTM ISDN or RTM LAN can be used for
Multiple Services configuration.
• On RMX 1500, when Multiple Network Services option is enabled,
the two networks must differ in their subnet masks.
• An IP Network Service can be associated with one or several media
cards.
• If more than one card is associated with the same Network Service,
the system routes the calls to the appropriate card according to
resource availability
• Participants on different networks can connect to the same
conference with full audio, video and content capabilities.
• Traffic on one network does not influence or affect the traffic on other
networks connected to the same MCU, unless they are connected to
Polycom RMX 1500/2000/4000 Administrator's Guide
14-63