Configuring The Video/Voice Resources In Mpm Mode - Polycom RMX 1500 Administrator's Manual

Chapter 19-RMX Administration and Utilities
19-60
conjunction with the Resource Report, it gives the administrator precise
control over resource allocation and optimization. Fixed Resource Capacity
mode is available only in MPM+ and MPMx System Card Configuration
Modes.
If all resources configured to a specific video resolution are in use and an
endpoint tries to connect to the RMX with that resolution, the RMX first
attempts to connect the endpoint using resources of the next highest
resolution level. If no resources are available at that level, the RMX tries to
connect the endpoint using resources of progressively decreasing
resolutions.
Example: In a system that has 10 SD ports allocated and in use, If another
SD endpoint (11th) attempts to connect, the system first tries to allocate
resources to the SD endpoint first from HD720 and then from HD1080
resources.
If HD resources are allocated to an SD endpoint, HD endpoints may
experience a resource deficiency when trying to connect and may not be
connected at HD resolution.
If there are no available HD resources the system tries to allocate
resources to the SD endpoint from any available CIF resources.
If there are no available CIF resources the system tries to allocate
resources to the SD endpoint from any available Audio Only resources. If
Audio Only resources are allocated the HD endpoint, the participant
receives an "Audio Only" message from the Conference/Entry Queue IVR
Service and is connected as an Audio Only participant.

Configuring the Video/Voice Resources in MPM Mode

Resource re-configuration should only be performed when no conferences are
running on the RMX.
From Version 7.1, MPM media cards are not supported.