Enabling Network Separation - Polycom RMX 1500 Administrator's Manual

After Network Separation has been performed, the Alternate Management
Network is no longer available for support purposes. For more information, see
"Alternate Management Network" on page

Enabling Network Separation

To enable Network Separation:
1 On the RMX menu, click Setup > System Configuration.
The System Flags dialog box opens.
2
For both the JITC_MODE and
SEPARATE_MANAGEMENT_NETWORK System Flags:
a Locate and double-click on the System Flag entry.
The Update Flag Name dialog box opens.
b
In the New Value field, enter YES.
c
Click the OK button to close the Update Flag Name dialog box.
3 Click the OK button to close the System Flags dialog box.
4
In the Reset Confirmation dialog box, click No.
5
In the RMX Management pane, click the IP Network Services (
button.
6
In the IP Network Services list pane, right-click the Management
Network ( ) entry and select Properties.
7
Enter the Control Unit IP, Shelf Management IP and Subnet Mask
addresses in their respective field boxes.
8
Click the Routers tab.
9 Enter the Default Router IP Address.
10 Click the OK button.
A Reset Confirmation dialog box is displayed.
11 Connect a workstation that is connected to the Management LAN to
the RMX's LAN 3 port.
12 In the Reset Confirmation dialog box, click Yes.
System restart may take up to five minutes.
Polycom RMX 1500/2000/4000 Administrator's Guide
G-1
)
14-91