Polycom RMX 1500 Administrator's Manual page 852

Appendix A-Disconnection Causes
A-4
Table A-1 Call Disconnection Causes (Continued)
Disconnection Cause
H323 call closed. Local
capability wasn't accepted
by remote
H323 failure
H323 call closed. Remote
stop responding
H323 call closed. Master
slave problem
SIP bad name
SIP bad status
SIP busy everywhere
SIP busy here
SIP capabilities don't
match
SIP card rejected channels
SIP client error 400
SIP client error 402
SIP client error 405
Description
The endpoint did not accept the capabilities sent
by the gatekeeper.
Internal error occurred.
The endpoint stopped responding.
A People + Content cascading failure occurred.
The conference name is incompatible with SIP
standards.
A general IP card error occurred.
The participant's endpoints were contacted
successfully, but the participant is busy and does
not wish to take the call at this time.
The participant's endpoint was contacted
successfully, but the participant is currently not
willing or able to take additional calls.
The remote device capabilities are not
compatible with the conference settings.
The IP card could not open the media channels.
The endpoint sent a SIP Client Error 400 (Bad
Request) response.
The request could not be understood due to
malformed syntax.
The endpoint sent a SIP Client Error 402
(Payment Required) response.
The endpoint sent a SIP Client Error 405
(Method Not Allowed) response.
The method specified in the Request-Line is
understood, but not allowed for the address
identified by the Request-URI.