Polycom RMX 1500 Administrator's Manual page 878

Appendix B-Alarms and Faults
Table B-1 Alarms (Continued)
Alarm Code
Product Type mismatch. System is
restarting.
Recording device has disconnected
unexpectedly
Red Alarm
Resource process did not receive the
Meeting Room list during startup.
Resource process failed to request the
Meeting Room list during startup.
Restore Failed
Restore Succeeded
Restoring Factory Defaults. Default
system settings will be restored once
Reset is completed
RTM ISDN card not found
RTM ISDN card startup procedure error
Secured SIP communication failed
B-12
Alarm Description
The user is alerted to a mismatch between the product
type that is stored in MCU software and the product type
received from another system component.
In such a case the system is automatically restarted.
When a certain timeout will be reached (after startup),
MCMS will go over the configured Spans. A configured
Span that is related to nonexistent card – will produce a
'RED_ALARM' Alert. Similarly on HotSwap: if an RTM
card (or an MPM that has an RTM extension) is
removed, MCMS will go over the configured Spans. A
configured Span that is related to the removed card – will
produce a 'RED_ALARM' Alert.
Without the Meeting Rooms list, the system cannot
allocate the appropriate dial numbers, Conference ID
etc. and therefore cannot run conferences
Without the Meeting Rooms list, the system cannot
allocate the appropriate dial numbers, Conference ID
etc. and therefore cannot run conferences
Restoring the system configuration has failed as the
system could not locate the configuration file in the
selected path, or could not open the file.
Restoring the system configuration has succeeded.
Reset the MCU.
Default system settings will be restored once Reset is
completed.
RTM ISDN card is missing.
The RTM ISDN card cannot complete its startup
procedure (usually after system reset)