Polycom RMX 1500 Administrator's Manual page 464

14-26
Table 14-9 Default IP Network Service – SIP Servers (Continued)
Field
Transport Type
Create Certificate
Certificate Method
Send Certificate
SIP Servers: Primary / Alternate Server Parameter
Server IP Address
Description
Select the protocol that is used for signaling
between the MCU and the SIP Server or the
endpoints according to the protocol supported by the
SIP Server:
UDP – Select this option to use UDP for signaling.
TCP – Select this option to use TCP for signaling.
TLS – The Signaling Host listens on secured port
5061 only and all outgoing connections are
established on secured connections. Calls from SIP
clients or servers to non secured ports are rejected.
The following protocols are supported: TLS 1.0,
SSL 2.0 and SSL 3.0.
This button is used to create a Certificate Request to
be sent to a Certification Authority.
Select the method for sending the Certificate to the
RMX:
• CSR
•
PEM/PFX
For more information see "The Security Certificate"
on page H-82.
This button is used when Integrating the RMX Into
the Microsoft OCS Environment. For more
information, see "Setting the RMX for Integration
Into Microsoft Environment" on page H-1.
Enter the IP address of the preferred SIP server.
If a DNS is used, you can enter the SIP server
name.
Note: When in IPv4&IPv6 or in IPv6 mode, it is
easier to use Names instead of IP Addresses.
Chapter 14-Network Services