Polycom RMX 1500 Administrator's Manual page 757

10 Define the following parameters:
Table 19-18 SNMPv3 - Traps
Field
SNMP Trap Specifies the version, either Version1 2 or 3 of the traps
Version being sent to the IP Host. Polycom software supports the
standard SNMP version 1 and 2 traps, which are taken from
RFC 1215, convention for defining traps for use with SNMP.
Note: The SNMP Trap Version parameters must be defined
identically in the external SNMP application.
Trap This box lists the currently defined IP addresses of the
Destination Manager terminals to which the message (trap) is sent.
IP
Community
Name
User Name
Authenticati
on Protocol
Privacy
Protocol
11 Click the Add button to add a new Manager terminal.
The New Trap Destination dialog box opens.
12 Type the IP Address and the Community name of the manager
terminal used to monitor the MCU activity, and then click OK.
Polycom RMX 1500/2000/4000 Administrator's Guide
Description
Enter the IP address of the
SNMP trap recipient.
Enter the Community Name of
the manager terminal used to
monitor the MCU activity
Enter the name of the user that
is to have access to the trap.
Enter the authentication
protocol: MD5 or SHA.
Enter the privacy protocol:
DES or AES.
All
Versions
Version 1
and
Version 2
Version 3
19-93