Polycom RMX 1500 Administrator's Manual page 851

Table A-1 Call Disconnection Causes (Continued)
Disconnection Cause
H323 call closed. Remote
busy
H323 call closed. Normal
H323 call closed. Remote
reject
H323 call closed. Remote
unreachable
H323 call closed. Unknown
reason
H323 call closed. Faulty
destination address
H323 call closed. Small
bandwidth
H323 call closed.
Gatekeeper reject ARQ
H323 call closed. No port
left
H323 call closed.
Gatekeeper DRQ
H323 call closed. No
destination IP address
H323 call. Call failed prior
or during the capabilities
negotiation stage
H323 call closed. Audio
channels didn't open
before timeout
H323 call closed. Remote
sent bad capability
Polycom RMX 1500/2000/4000 Administrator's Guide
Description
The endpoint was busy. (Applicable only to dial-
out)
The call ended normally, for example, the
endpoint disconnected.
The endpoint rejected the call.
The gatekeeper could not find the endpoint's
address.
The reason for the disconnection is unknown, for
example, the endpoint disconnected without
giving a reason.
Incorrect address format.
The gatekeeper allocated insufficient bandwidth
to the connection with the endpoint.
The gatekeeper rejected the endpoint's ARQ.
There are no ports left in the IP card.
The gatekeeper sent a DRQ.
For internal use.
The endpoint did not send its capabilities to the
gatekeeper.
The endpoint did not open the audio channel.
There was a problem in the capabilities sent by
the endpoint.
A-3