Polycom RMX 1500 Administrator's Manual page 870

Appendix B-Alarms and Faults
Table B-1 Alarms (Continued)
Alarm Code
DEBUG mode enabled
DEBUG mode flags in use
DMA not supported by IDE device
DNS configuration error
DNS not configured in IP Network Service
Encryption Server Error. Failed to
generate the encryption key
Error in external database certificate
Error reading MCU time
External NTP servers failure
Failed to access DNS server
Failed to configure the Media card IP
address
Failed to configure the Users list in Linux
B-4
Alarm Description
Possible explanations:
•
System is running in DEBUG mode.
•
System DEBUG mode initiated.
System is using DEBUG CFG flags.
Possible explanations:
• DMA (direct memory access) not supported by IDE
device: Incompatible flash card / hard disk being
used.
•
Flash card / hard drive are not properly connected to
the board / one of the IDE channels is disconnected.
• DMA was manually disabled for testing.
FIPS 140 test failed while generating the new encryption
key.
Failed to read MCU time configuration file ([status]).
Failed to access DNS server.
Possible reasons for the failure:
•
Failure type: [OK Or Not supported.
•
Does not exist Or IP failure.
• Duplicate IP Or DHCP failure.
•
VLAN failure Or Invalid: [status_Number].
External NTP server failure:
NTP server failure: [server0_ip], [server1_ip],
[server2_ipStr].