Polycom RMX 1500 Administrator's Manual page 504

14-66
RMX unit. For a list of required address, see the RMX 1500/2000/
4000 Getting Started Guide, "Gather Network Equipment and Address
Information" on page 2-2.
— Unpack the RMX. For more details see the RMX 1500/2000/4000
Getting Started Guide, Chapter 2.
— Modify the Management Network parameters on the USB Key. For
more details see the RMX 1500/2000/4000 Getting Started Guide,
"Modifying the Factory Default Management Network Settings on the
USB Key" on page 2-9.
2
Hardware Installation and Setup
— Mount the RMX in a rack. For more details see the RMX 1500/
2000/4000 Getting Started Guide, "Hardware Installation and Setup"
on page 2-12.
— Connect the necessary cables. For details, see "RMX Hardware
Installation" on page 1.
3
First Entry Power-up and Configuration
— Power up the RMX. For more details see the RMX 1500/2000/
4000 Getting Started Guide, "Procedure 1: First-time Power-up" on
page 2-22.
— Register the RMX. For more details see the RMX 1500/2000/4000
Getting Started Guide, "Procedure 2: Product Registration" on
page 2-23.
— Connect to the RMX. For more details see the RMX 1500/2000/
4000 Getting Started Guide, "Procedure 3: Connection to MCU" on
page 2-24.
— Configure the Default IP Network Service using the information
for one of the networks connected a media card installed in the
system. For more details see the RMX 1500/2000/4000 Getting
Started Guide, "Procedure 4: Modifying the Default IP Service and
ISDN/PSTN Network Service Settings" on page 2-26.
— Optional. Configure the ISDN/PSTN Network Service. For more
details see the RMX 1500/2000/4000 Getting Started Guide.
4
Modify the required System Flag to enable Multiple Services and
reset the MCU.
5 Add the required IP Network Services to accommodate the networks
connected to the RMX unit.
6
Select a Network Service to act as default for dial out and gateway
calls for which the Network Service was not selected.
Chapter 14-Network Services