Polycom RMX 1500 Administrator's Manual page 513

Table 14-32 IP Network Service - IP Parameters
Field
IP Network Type
Signaling Host IP
Address
Media Card 1 IP
Address
Polycom RMX 1500/2000/4000 Administrator's Guide
Description
Select the IP Network environment. You can select:
•
H.323: For an H.323-only Network Service.
•
SIP: For a SIP-only Network Service.
• H.323 & SIP: For an integrated IP Service. Both
H.323 and SIP participants can connect to the
MCU using this service.
Note: This field is displayed in all Default IP Service
tabs.
Enter the address to be used by IP endpoints when
dialing into the MCU using this Network Service.
Dial out calls of participants to whom this network
service will be assigned are initiated from this
address.
This address is used to register the RMX with a
Gatekeeper or a SIP Proxy server residing on this
network.
If only one network is connected to this media card,
it is enough to assign one media card to this
Network Service. In such a case, enter one IP
address for the media card according to the LAN
Port used for the connection.
If each of the LAN ports on one media card is used
with two different networks, each port is assigned to
its own Network Service. In such a case, enter the
IP address of the port to be assigned to this Network
Service.
A LAN port that is already assigned to a different
Network Service, displays the IP Address of the
assigned port and it cannot be assigned to this
Network Service (it is disabled).
14-75