Polycom RMX 1500 Administrator's Manual page 505

Upgrading to Version 7.2.x and Multiple Services
7
Place several calls and run conferences to ensure that the system is
configured correctly.
1
Gather Network Equipment and Address Information for each of the
networks that will be connected to the RMX unit. For a list of
required address, see "Gather Network Equipment and Address
Information - IP Network Services Required Information" on page 1-1.
2 Upgrade the software version to Version 7.1 and install the activation
key that contains the Multiple Services license as described in RMX
1500/2000/4000 Release Notes, "Upgrade Paths to Version 7.2.1" on
page 14.
3
Place several calls and run conferences to ensure that the system
upgrade was completed successfully.
4 Modify the required System Flag to enable Multiple Services, DO
NOT reset the MCU yet.
5
Connect the additional network cables to the RMX and change
existing connections to match the required configuration as described
in the "RMX Hardware Installation" on page 1.
At this point, the Management Network can be modified to match the
required local network settings.
If the RMX 2000 you are upgrading does not include RTM ISDN or RTM LAN
cards, you must install at least one RTM LAN card to enable the definition of
multiple Network Services. If no RTM ISDN or RTM LAN cards are installed, the
RMX 2000 works in a single Network Service mode and an alarm is issued by
the system. For more details about the installation of RTM LAN cards, see the
RMX 2000 Hardware Guide.
6
Reset the MCU.
7
Connect to the MCU and Add the required IP Network Services to
accommodate the networks connected to the RMX unit.
8
Select a Network Service to act as default for dial out and gateway
calls for which the Network Service was not selected.
9
Place several calls and run conferences to ensure that the system is
configured correctly.
Polycom RMX 1500/2000/4000 Administrator's Guide
14-67