Polycom RMX 1500 Administrator's Manual page 514

14-76
Table 14-32 IP Network Service - IP Parameters
Field
Media Card 2 IP
Address
(RMX 2000/4000)
Media Card 3 IP
Address
(RMX 4000)
Media Card 4 IP
Address
(RMX 4000)
Subnet Mask
4
Optional. Some system flags can be defined per Network Service,
depending on the network environment.
To modify these flags, click the Service Configuration button.
Description
If only one network is connected to this media card,
it is enough to assign one media card to this
Network Service. In such a case, enter one IP
address for the media card according to the LAN
Port used for the connection, as provided by the
network administrator.
If each of the LAN ports on one media card is used
with two different networks, each port is assigned to
its own Network Service. In such a case, enter the
IP address of the port to be assigned to this Network
Service.
Notes:
•
LAN Ports/Media cards that are already
associated with another Network Service cannot
be associated with this Network Service.
•
You can define a Network Service without
assigning media cards to it.
•
To change the assignment of a card from one
service to another, the card must first be
removed from the service to which it is assigned
prior to its assignment to another service.
RMX 2000: If one card was already assigned to
another service, only one additional card can be
assigned to this service.
RMX 4000: Depending on the number of media
cards installed in the system, you can assign up to 4
media cards to this network service provided that
they are not assigned to any other Network Service.
Enter the subnet mask of the MCU in that network
service.
Default value: 255.255.255.0.
Chapter 14-Network Services