Rmx Configuration - Polycom RMX 1500 Administrator's Manual

RMX Configuration

Table 14-31 LAN Connections to the RTM IP
RTM IP Port Description
Shelf Shelf Management
LAN 3 –
LAN 4 –
Modem Modem
Once the network cables are connected to the RMX unit, you can modify
the default IP Network Service and add additional Network Services.
System Flags and License Settings
The MULTIPLE_SERVICES System Flag determines whether the
Multiple Services option will be activated once the appropriate license is
installed. Possible Values: YES / NO Default: NO
This flag must be manually added to the system configuration and set to
YES to enable this option. For more information see the RMX 1500/2000/
4000 Administrator's Guide, "Manually Adding and Deleting System Flags"
on page 19-21.
If the MULTIPLE_SERVICES System Flag is set to YES and no RTM ISDN or
RTM LAN card is installed in the RMX 2000, an Active Alarm is displayed.
IP Network Service Definition
Use this procedure to define Network Services in addition to the Network
Service already defined during first entry installation and configuration.
Each of the defined Network Service can be associated with one or more
media cards installed in the system (depending on the system type).
Once a media card is associated with a Network Service it cannot be
associated with another network service.
To add new/additional Network Services:
1 In the Device Management pane, click IP Network Services (
Polycom RMX 1500/2000/4000 Administrator's Guide
).
14-73