Polycom RMX 1500 Administrator's Manual page 875

Table B-1 Alarms (Continued)
Alarm Code
Internal MCU reset
Internal System configuration during
startup
Invalid date and time
Invalid MCU Version
Invalid System Configuration
IP addresses of Signaling Host and
Control Unit are the same
IP Network Service configuration modified
IP Network Service deleted
Polycom RMX 1500/2000/4000 Administrator's Guide
Alarm Description
Possible explanations:
•
McmsDaemon reset due to policy decision: [Process
failed [abs crash counter: crash counter]: process
name].
•
McmsDaemon reset due to policy decision: [Process
failed [abs crash counter: crash counter]: process
name]; Cannot reset while system is in DEBUG
mode.
•
Power down signal was detected.
•
[CS Component Failure; unit type:
[NonComponent\CSMngnt\CSH323\CSSIP]\CS
Component Failure; unit type: (invalid: [unit type])\No
connection with CS]; Cannot reset while system is in
DEBUG mode.
•
Reset cause unknown: [reset source]\Restore
Factory Defaults - [mcu restore name]\CM_Loaded
indication repeated; boardId: [boardId]\reset from
Cards process - simulation\No connection with MPM;
board Id:[boardId]\SmMfaFailure - boardId: [boardId].
Status: [status], problem bitmask:
[problemBitMask]\MPM failure, boardId:
[slotId]\Switch failure\No connection with Switch.
System configuration during startup.
Invalid date and time:
MCU year ([year]) must be 2000 or later.
MCU Version: [Major.Minor.release.internal].
IP Network Service was modified.
Reset the MCU.
IP Network Service was deleted.
Reset the MCU.
B-9