Polycom RMX 1500 Administrator's Manual page 910

Appendix C-CDR Fields - Unformatted File
C-28
Table C-11 Event fields for Event 5 - ISDN/PSTN PARTICIPANT
CONNECTED (Continued)
Field
Secondary Cause
(cont.)
Table C-12 Event Fields for Event 7 - PARTICIPANT DISCONNECTED
Field
Participant Name
Participant ID
Call Disconnection
Cause
Q931 Disconnect
Cause
Description
15 - Video stream violation due to incompatible annexes
or other discrepancy.
16 - Inadequate video resources
17 - When moved to a Transcoding or Video Switching
conference, the participant's video capabilities are not
supported by the video cards
18 - Video connection could not be established
24 - The endpoint closed its video channels
25 - The participant video settings are not compatible
with the conference protocol
26 - The endpoint could not re-open the video channel
after the conference video mode was changed
27 - The gatekeeper approved a lower bandwidth than
requested
28 - Video connection for the SIP participant is
temporarily unavailable
29 - AVF problem. Insufficient bandwidth.
30 - H2.39 bandwidth mismatch
255 - Other
Description
The name of the participant.
The identification number assigned to the participant by
the MCU.
The disconnection cause. For more information about
possible values, see Table C-37, "Disconnection Cause
Values", on page C-55.
If the disconnection cause is "No Network Connection"
or "Participant Hang Up", then this field indicates the
Q931 disconnect cause.