Polycom RMX 1500 Administrator's Manual page 840

Chapter 20-RMX Hardware Monitoring
20-42
Run all Test Selection
Diagnostics Test Monitoring
Figure 20-4 RMX 1500 Diagnostics Tests & Monitoring Tests
5
When the RMX enters "Diagnostics Mode", the status MPM+/MPMx,
CNTL/CNTL 1500/CNTL 4000 and RTM IP/RTM IP 1500/RTM IP
4000 changes to "Diagnostics".
You can run "Diagnostics" tests on a MPM+/MPMx card by double
clicking any one of the hardware components indicating
"Diagnostics" in the status column.
Figure 20-5 RMX 2000/4000 MPMx D - DSP DSP Sub Test selection
Run a "Diagnostics" test on a CTNL card by clicking the CTNL hardware
component that indicates "Diagnostics" in the status column.