Value Range
Default Value
Phone User Interface
Reference
4.4.2 Ethernet Port Settings
This screen allows you to change the connection mode of the Ethernet ports and the VLAN settings.
Note
•
When you change the settings on this screen and click [Save], the message "Complete" is displayed,
and then the unit will restart automatically even if the unit is on a call.
•
Incorrect settings may cause a network failure. In such a case, you cannot access the Web user
interface anymore. To access it again, you need to correct the speed/duplex settings or perform IP
Reset through phone user interface programming. For details, refer to the Operating Instructions on
the Panasonic Web site (® see Introduction).
4.4.2.1 Link Speed/Duplex Mode
LAN Port
Description
Value Range
Default Value
Phone User Interface
Reference
Document Version 2011-11
Max. 15 characters
Not stored.
Network Settings (Page 14)
Selects the connection mode (link speed and duplex mode) of the LAN
port.
•
Auto Negotiation
•
100 Mbps/Full Duplex
•
100 Mbps/Half Duplex
•
10 Mbps/Full Duplex
•
10 Mbps/Half Duplex
Auto Negotiation
Ethernet Settings (Page 15)
Section 4 Web User Interface Programming
Administrator Guide
59