Table of Contents
Advertisement
Chapter 2 OPERATION
Section 5 DAILY OPERATION
The way of supplying with the board from the non-segmented front stocker is shown in this
section.
When supplying with the board from the step load front stocker, which is set in the preceding
process, turn on the power supply and the PASS switch on the operation panel.
5-1
Start Automatic Operation
5-1-1
Turn on Machine and Start Automatic Operation
1. Recognizing the air pressure
• Make sure of matters as follow before you start the machine.
∗ Check the step load front stocker, which is equipped with the air unit, in the preceding
process.
AIR OUT
014C-PS010
• When the air pressure comes down when the machine is working, the machine will stop for
emergency.
2. Turn on the power supply.
013C-E-OMA05-A01-00
Open
moderate air pressure is over 0.5~0.55MPa {5.1~5.6kgf/cm
CONVEYOR
ON
POWER SW.
POWER SW.
Section 5 DAILY OPERATION
6
4
2
8
kgf/cm
2
10
013C-IL004
rear side
PASS
5
013C-IL003
2
}
Page 5-1
Advertisement
Table of Contents
