Port Troubleshooting - Planet XGS3-42000R User Manual

Switch1
Switch2
Switch3
The configurations are listed below:
Switch1:
Switch1(config)#interface ethernet 1/7
Switch1(Config-If-Ethernet1/7)#bandwidth control 50 both
Switch2:
Switch2(config)#interface ethernet 1/9
Switch2(Config-If-Ethernet1/9)#speed-duplex force100-full
Switch2(Config-If-Ethernet1/9)#exit
Switch2(config)#interface ethernet 1/10
Switch2(Config-If-Ethernet1/10)# speed-duplex force1000-full
Switch2(Config-If-Ethernet1/10)#exit
Switch2(config)#monitor session 1 source interface ethernet1/8;1/9
Switch2(config)#monitor session 1 destination int erface et hernet 1/10
Switch3:
Switch3(config)#interface ethernet 1/12
Switch3(Config-If-Ethernet1/12)#speed-duplex force1000-full
Switch3(Config-If-Ethernet1/12)#exit

7.4 Port Troubleshooting

Here are some situations that frequently occurs in port configuration and the advised solutions:
 Two connected fiber interfac es won't link up if one interface is set to auto-negotiation but the other to
forced speed/duplex. This is determined by IEEE 802.3.
 The following combinations are not recommended: enabling traffic control as well as setting multicast
limiting for the same port; setting broadc ast, multicast and unk nown destination unicast control as well
as port bandwidth limiting for the same port. If such combinations are set, the port throughput may fall
below the expected performanc e.
1/7
1/8
1/9
1/10
1/12
Ingress bandwidth limit: 150 M
Mirror sourc e port
100Mbps full, mirror source port
1000Mbps full, mirror destination port
100Mbps full
7-3