Igmp Configuration Examples - Planet XGS3-42000R User Manual

no ip dvmrp | no ip pim
dense-mode | no ip pim
sparse-mode | no ip dvmrp
multicast-routing | no ip pim
multicast-routing

43.9.3 IGMP Configuration Examples

As shown in the following figure, add the Ethernet ports of Switch A and Switch B to corresponding VLAN, and
start PIM-DM on eac h VLAN interface.
The configuration procedure for SwitchA and SwitchB is as follows:
(1) Configure SwitchA:
XGS 3-42000R(config)#ip pim multicast-routing
XGS 3-42000R(config)#interface vlan 1
XGS 3-42000R(config-if-Vlan1)#ip address 12.1.1.1 255.255.255.0
XGS 3-42000R(config-if-Vlan1)#ip pim dense-mode
(2) Configure SwitchB:
XGS 3-42000R(config)#ip pim multicast-routing
XGS 3-42000R(config)#interface vlan1
XGS 3-42000R(config-if-Vlan1)#ip address 12.1.1.2 255.255.255.0
XGS 3-42000R(config-if-Vlan1)#ip pim dense-mode
XGS 3-42000R(config-if-Vlan1)#exit
XGS 3-42000R(config)#interface vlan2
XGS 3-42000R(config-if-Vlan1)#ip address 20.1.1.1 255.255.255.0
XGS 3-42000R(config-if-Vlan2)#ip pim dense-mode
XGS 3-42000R(config-if-Vlan2)#ip igmp version 3
Disable IGMP Protocol.
SwitchA
Ethernet1/1
vlan1
IGMP Network Topology Diagram
Figure 43-9-1
SwitchB
Ethernet1/1
vlan1
43-46
Ethernet1/2
vlan2