Table of Contents
Advertisement
38.2 OSPFv3 Configuration Task List
OSPFv3 Configuration Task List:
1.
Enable OSPFv3 (required)
（1）
Enable/disable OSPFv3(required)
（2）
Configure the router-id number of the layer3 switch running OSPFv3 (optional)
（3）
Configure the network scope for running OSPFv3 (optional)
（4）
Enable OSPFv3 on the interface (required)
2.
Configure OSPFv3 auxiliary parameters (optional)
（1）
Configure OSPFv3 packet sending mec hanism parameters
1)
Set the OSPFv3 int erface to receive only
2)
Configure the cost for sending packets from the interface
3)
Configure OSPFv3 packet sending timer parameter (timer of broadcast interface sending HELLO
packet to poll, timer of neighboring layer3 switch invalid timeout, timer of LSA transmission delay
and timer of LSA retransmission.
（2）
Configure OSPFv3 route introduction paramet ers
1)
Configure default parameters (default type, default tag value, default cost)
2)
Configure the routes of the other protocols to introduce to OSPFv3
（3）
Configure OSPFv3 importing the routes of other OSPFv3 processes
1)
Enable the function of OSPFv3 importing the routes of other OSPFv3 processes
2)
Display relative information
3)
Debug
（4）
Configure other OSPFv3 protocol parameters
1)
Configure OSPFv3 routing prot ocol priority
2)
Configure cost for OSPFv3 S TUB area and default route
3)
Configure OSPFv3 virtual link
4)
Configure the priority of the interface when electing designat ed layer3 switch
3. Close OSPFv3 Protocol
1. Enable OSPFv3 Protocol
It is very simple to run the basic configurations of OSPFv3 routing protocol on the Layer 3 switch of XGS 3
series switch, normally only enabling OSPFv3, implement OSPFv3 int erface, the default value is defined to
OSPFv3 protocol parameters. Refer to 2. Configure OSPF auxiliary parameters, if the OSPFv3 protocol
parameters need to be modified.
Global Mode
[no] router IPv6 ospf <tag>
OSPFv3 Protocol Configure Mode
Commands
Explanation
The command initializes OSPFv3 routing
process
and
enter
configure OSPFv3 routing process. The [no]
router IPv6 ospf <tag> command stops
relative process. (required)
38-4
OSPFv3
mode
to
Advertisement
Table of Contents
Troubleshooting
