Planet XGS3-42000R User Manual page 59

The IP address configuration commands for VLA N1 interface are listed below. Before in-band management,
the switch must be configured with an IP address by out-of-band management (i.e. Console mode), the
configuration commands are as follows (All switch configuration prompts are assumed to be "XGS3-42000R"
hereafter if not otherwise specified):
XGS 3-42000R>
XGS 3-42000R>enable
XGS 3-42000R#config
XGS 3-42000R(config)#interface vlan 1
XGS 3-42000R(Config-if-Vlan1)#ip address 10.1.128. 251 255. 255.255.0
XGS 3-42000R(Config-if-Vlan1)#no shutdown
To enable the Telnet Server function, users should type the CLI command telnet-s erver enable in the global
mode as below:
XGS 3-42000R>enable
XGS 3-42000R#config
XGS 3-42000R(config)# telnet-s erver enable
Step 2: Run Telnet Client program.
Run Telnet client program included in Windows with the specified Telnet target.
Step 3: Login to the Chassis Switch.
Login to the Telnet configuration interface. Valid login name and password are required, otherwise the
Chassis Switch will reject Telnet access. This is a method to prot ect the Chassis Switch from unaut horized
access. As a result, when Telnet is enabled for configuring and managing the Chassis Switch, username and
password for authorized Telnet users must be configured with the following command:
username <username> privilege <privilege> [password (0|7) <password>].
To open the local authentication style with the following command: authentication line vty login local. Privilege
option must exist and just is 15. Assume an authorized user in the Chassis Switch has a us ername of "test",
and password of "test", the configuration procedure should like the following:
Figure 3-1-7 Run telnet client program included in Windows
3-29