Planet XGS3-42000R User Manual page 61

management chapt er.
To enable the WEB configuration, users should type the CLI command IP http server in the global mode as
below:
XGS 3-42000R>enable
XGS 3-42000R#config
XGS 3-42000R(config)#ip http server
Step 2: Run HTTP protocol on the host.
Open the Web browser on the host and type the IP address of the Chassis Switch, or run directly the HTTP
protocol on the Windows. For example, the IP address of the Chassis Switch is "10.1.128. 251";
When accessing a Chassis Switch wit h IP v6 address, it is recommended to use t he Firefox browser with 1.5
or later version. For example, if the IP v6 address of the Chassis Switch is 3ffe: 506:1: 2::3. Input the IP v6
address of the Chassis Switch is
square brackets.
Step 3: Login to the Chassis Switch.
Login to the Web configuration int erface. Valid login name and password are required, otherwise the Chassis
Switch will reject HTTP access. This is a method to protect the Chassis Switch from unauthorized access. As
a result, when Telnet is enabled for configuring and managing the Chassis Switch, username and password
for authorized Telnet users must be configured wit h the following command:
username <usernam e> privilege <privilege> [password (0|7) <password>]
To open the local aut hentication style with the following command: authentication line web login local.
Privilege option must exist and just is 15. Assume an authorized user in the Chassis Switch has a username
of "admin", and password of "admin", the configuration procedure should like the following:
XGS 3-42000R>enable
XGS 3-42000R#config
XGS 3-42000R(config)#username admin privilege 15 password 0 admin
XGS 3-42000R(config)#aut hentication line web login local
The Web login interface of XGS 3-42000R is as below:
Figure 3-1-9 Run HTTP Protocol
http://[3ffe:506:1:2::3]
3-31
and the address should draw t oget her with the