Mld Typical Application - Planet XGS3-42000R User Manual

ipv6 mld query-max-response-time
<time_val>
no ipv6 mld
query-max-response -time
ipv6 mld query-timeout <time_val>
no ipv6 mld query-timeout
3. Shut down MLD Protocol
Port Configuration Mode
no ipv6 pim dense-mode | no ipv6
pim sparse-mode | no ipv6 pim
multicast-routing (Global Mode)

44.6.3 MLD Typical Application

As shown in the following figure, add the Ethernet interfaces of S witch A and S witch B to corresponding vlan,
and start PIM6 on each vlan interface.
The configuration procedure for SwitchA and SwitchB is as below:
(1) Configure SwitchA:
XGS 3-42000R(config) #ipv6 pim multicast-routing
XGS 3-42000R(config) #ipv6 pim rp-address 3FFE::1
XGS 3-42000R(config) #interfac e vlan 1
XGS 3-42000R(Config-if-Vlan1) #ipv6 address 3FFE::1/64
XGS 3-42000R(Config-if-Vlan1) #ipv6 pim sparse-mode
(2) Configure SwitchB:
Command
SwitchA
Vlan 1
Figure 44-6-1 Network Topology Diagram
Configure the maximum response time of the
interface for MLD query; the NO operation of this
command restores the default value.
Configure the overtime of the interface for MLD
query; the NO operation of this command
restores the default value.
Explanation
Shut down MLD Protoc ol
Vlan 1
44-26
SwitchB
Vlan 2