2.2 Install the Chassis Switch
This section describes how to install your Chassis Switch and mak e connections to the Chassis Switch.
Please read the following topics and perform the procedures in the order being presented. To install your
Chassis Switch on a desktop or shelf, simply complete the following steps.
During the installation, please take care and avoid crash, that may cause the device damage.
Due t o the XGS 3-42000R is heavy, please take care safety for installer. Pleas e make sure the
hardware had been located on the rack properly. If the hardware drops down, it is possible
make someone hurt. Please check the hardware again after the installation.
Max full configuration weight is 30KG.
2.2.1 Desktop Installation
To install the Chassis Switch on desktop or shelf, please follows these steps:
Step1:
Attach the rubber feet to the recessed areas on the bottom of the Chassis Switch.
Step2:
Place the Chassis Switch on the desktop or the shelf near an AC power source, as shown in
2-2-1.
Step3:
Keep enough ventilation spac e between the Chassis Switch and the surrounding objects.
When choosing a location, please keep in mind the environmental restrictions discussed in
Chapter 1, Section 4, and Specification.
Figure 2-2-1 Place the Chassis Switch on the desktop
2-12
Figure