Pim-Sm6 Typical Application - Planet XGS3-42000R User Manual

4. Di sable PIM-SM protocol
Interface Configuration Mode
no ipv6 pim sparse-mode
Global Configuration Mode
no ipv6 pim sparse-mode

44.2.3 PIM-SM6 Typical Application

As shown in the following figure, add the Ethernet interfaces of S witchA, SwitchB, SwitchC and S witchD to
corresponding VLAN, and start PIM-SM Protocol on each VLAN interface.
Vlan 2
Vlan 2 bsr
Vlan 3
The configuration procedure for SwitchA, SwitchB, SwitchC and SwitchD is as below:
(1) Configure SwitchA:
XGS 3-42000R(config)#ipv6 pim multicast-routing
XGS 3-42000R(config)#interface vlan 1
XGS 3-42000R(config-if-Vlan1)#ipv6 address 2000:12:1:1::1/64
XGS 3-42000R(config-if-Vlan1)#ipv6 pim spars e-mode
XGS 3-42000R(config-if-Vlan1)#exit
XGS 3-42000R(config)#interface vlan 2
XGS 3-42000R(config-if-Vlan2)#ipv6 address 2000:13:1:1::1/64
XGS 3-42000R(config-if-Vlan2)#ipv6 pim spars e-mode
(2) Configure Switch B:
XGS 3-42000R(config)#ipv6 pim multicast-routing
XGS 3-42000R(config)#interface vlan 1
Command
SwitchA
Vlan 1
SwitchC
Vlan 1
Figure 44-2-1
To disable the P IM-SM6 protocol.
To disable PIM-DM globally.
vlan 1
Vlan 2
Vlan 1
PIM-SM Typical Environment
44-10
Explanation
SwitchB
Vlan 2 rp
SwitchD
Vlan 3