Planet XGS3-42000R User Manual page 83

operation result is shown below:
[Boot]:
Step 3:
Under BootROM mode, run "setconfig" to set the IP address and mask of the Chassis Switch under BootROM
mode, server IP address and mask, and select TFTP or FTP upgrade. Suppose the Chassis Switch address
is 192.168.1.2, and P C address is 192.168.1.66, and select TFTP upgrade, the configuration should like:
[Boot]: setconfig
Host IP Address: [10.1.1.1] 192. 168.1. 2
Server IP Address: [10.1.1.2] 192.168.1.66
FTP (1) or TFTP(2): [1] 2
Network interface configure OK.
[Boot]
Step 4:
Enable FTP/ TFTP server in the PC. For TFTP, run TFTP server program; for FTP, run FTP server program.
Before start downloading upgrade file to the Chassis Switch, verify the connectivity between the server and
the Chassis Switch by ping from the server. If ping succeeds, run "load" command in the Boot ROM mode from
the Chassis Switch; if it fails, perform troubleshooting to find out the cause. The following is the c onfiguration
for system update image file.
[Boot]: load nos.img
Loading...
Loading file ok !
Step 5:
Execute "writ e nos.img" in BootROM mode. The following saves the system update image file.
[Boot]: write nos.img
File nos.img exists, overwrite? (Y/N)?[N] y
Writing nos.img.....................................................
Write nos.img OK.
[Boot]:
Step 6:
The following update file boot.rom, the basic environment is the same as Step 4.
[Boot]: load boot.room
Loading...
Loading file ok !
Step 7:
Execute "writ e boot.rom" in BootROM mode. The following saves the update file.
[Boot]: write boot.rom
4-15