Planet XGS3-42000R User Manual page 308

router-id <router_id>
no router-id
[no] pa ssive-interface<ifname>
Interface Configuration Mode
[no] IPv6 router ospf {area <area-id>
[instance-id <instance-id> | tag <tag>
[instance-id <instance-id>]] | tag <tag>
area <area-id> [instance-id
<instance-id>]}
2. Configure OSPFv3 parameters
（1）Configure OSPFv3 packet sending mechanism parameters
1）Set the OSPF interface to receive only
2）Configure the cost for sending packets from the interfac e
Interface Configuration Mode
IPv6 ospf cost <cost> [instance-id
<id>]
no IPv6 ospf cost [instance-id <id>]
3）Configure OSPFv3 packet sending timer parameter (timer of broadcast interface sending HELLO packet to
poll, timer of neighboring layer3 switch invalid timeout, timer of LSA transmission delay and timer of LSA
retransmission.
Interface Configuration Mode
IPv6 ospf hello-interval <time>
[instance-id <id>]
no IPv6 ospf hello-interval
[instance-id <id>]
IPv6 ospf dead-interval <time>
[instance-id <id>]
no IPv6 ospf dead-interval
[instance-id <id>]
IPv6 ospf transit-delay <time>
[instance-id <id>]
no IPv6 ospf transit-delay
[instance-id <id>]
Commands
Commands
Configure router for OSPFv3 process. The
no router-id
0.0.0.0 .(required)
Configure an interface receiving without
sending.
passive-interface<ifname>command
cancels configuration.
Implement OSPFv3 routing on the interface.
The [no] IPv6 router ospf {area <area-id>
[instance-id <instance-id> | tag <tag>
[instance-id <instance-id>]] | tag <tag>
area <area-id>
<instance-id>]}
configuration.
Explanation
Appoint interface to implement required cost of
OSPFv3 protocol. The no IPv6 OSPF cost
[instance-id <id>] restores the default setting.
Explanation
Sets interval for sending HELLO packets; the
"no IPv6 ospf hello-interval [instance-id
<id>]" command restores the default setting.
Sets the interval before regarding a neighbor
layer3 switch invalid; the "no IPv6 ospf
dead-interval [instance-id <id>]" command
restores the default setting.
Sets the delay time before sending link-state
broadcast; the "no IPv6 ospf transit-delay
[instance-id <id>]" command restores the
default setting.
38-5
command returns ID to
The
[instance-id
command c ancels
[no]