Table of Contents
Advertisement
Remove the Fan Tray
Step1
Loosen the 2 screws in the front panel of the fan tray.
Step2
Hold the handle in the front panel of fan tray with your middle and ring fingers, press the locker slightly
down, and the fan tray can be drawn out smoothly.
The installation and removal of a fan tray is shown below
2.2.7 Removing / Installing the Power Supply Unit
To install a power supply unit into XGS3-42000R, please fasten the hand screw clockwise and slide in the power
supply unit into the XGS3-42000R.
Pleaes slid in the PWR-AC module first before plug-in the rear power cord.
To remove a power supply unit out the XGS3-42000R, please loose the hand screw counter clockwise and pull out the
power supply unit from the XGS3-42000R.
Please put back the front cover after the PRW-AC module is removed.
Figure
Figure 2-2-7 Installation and Removal the Fan Tray
2-18
2-2-7:
Advertisement
Table of Contents
Troubleshooting
