Table of Contents
Advertisement
XGS 3-42000R(config-If-Ethernet1/3)#switchport mode trunk
XGS 3-42000R(config-If-Ethernet1/3)#exit
XGS 3-42000R(config)#monitor session 1 source interface ethernet1/1 rx
XGS 3-42000R(config)#monitor session 1 reflector-port ethernet 1/3
XGS 3-42000R(config)#monitor session 1 remote vlan 5
Intermediate switch:
Interface ethernet1/6 is the source port which is connected to the source switch.
Interface ethernet1/7 is the destination port which is connected to the destination switch. The native VLA N of
the port should not be configured as RSPAN VLAN, or the mirrored data may not be carried by the destination
switch.
RSPAN VLA N is 5.
XGS 3-42000R(config)#vlan 5
XGS 3-42000R(config-Vlan5)#remote-span
XGS 3-42000R(config-Vlan5)#exit
XGS 3-42000R(config)#interface ethernet 1/6-7
XGS 3-42000R(config-If-Port-Range)#switchport mode trunk
XGS 3-42000R(config-If-Port-Range)#exit
Destination switch:
Interface ethernet1/9 is the source port which is connected to the source switch.
Interface ethernet1/10 is the destination port which is connected to the monitor. This port is required to be
configured as an access port, and belong to the RSPA N VLAN.
RSPAN VLA N is 5.
XGS 3-42000R(config)#vlan 5
XGS 3-42000R(config-Vlan5)#remote-span
XGS 3-42000R(config-Vlan5)#exit
XGS 3-42000R(config)#interface ethernet 1/9
XGS 3-42000R(config-If-Ethernet1/9)#switchport mode trunk
XGS 3-42000R(config-If-Ethernet1/9)#exit
XGS 3-42000R(config)#interface ethernet 1/10
XGS 3-42000R(config-If-Ethernet1/10)#s witchport access vlan 5
XGS 3-42000R(config-If-Ethernet1/10)#exit
56.4 RSPAN Troubleshooting
Due to the following reasons, RSPAN may not function:
56-6
Advertisement
Table of Contents
Troubleshooting
