Planet XGS3-42000R User Manual page 267

3. Configure RIP-I/RIP-II switch
(1) Configure the RIP version to be used in all interfac es
(2) Configure the RIP version to send/receive in all interfaces
(3) Configure whether to enable RIP packets sending/receiving for interfaces
4. Delete the specified route in RIP route table
5. Configure the RIP routing aggregation
(1) Configure aggregation route of IP v4 route mode
(2) Configure aggregation route of IP v4 int erface configuration mode
(3) Display IP v4 aggregation route information
6. Configure redistribution of OSPF routing to RIP
(1) Enable Redistribution of OSPF routing to RIP
(2) Display and debug the information about configuration of redistribution of OSPF routing to RIP
1. Enable RIP protocol
Applying RIP route protocol with basic configuration in switch is simple. Normally you only have to open the
RIP switch and configure the segments running RIP, namely send and receive the RIP data packet by
default RIP configuration. The version of data packet sending and receiving is variable when needed,
allow/ deny sending, receiving RIP data packet. Refer to 3.
Global Mode
router rip
no router rip
Rout er and address family configuration
mode
network <A.B.C.D/M | ifname|vl an>
no network <A.B.C.D/M | ifname|vl an>
2. Configure RIP protocol parameters
（1）Configure RIP packet transmitting mechanism
1）Configure the RIP data packet point-transmitting
2）Configure the Rip broadcast
Rout er Configuration Mode
neighbor <A.B.C.D>
no neighbor <A.B.C.D>
passi ve-interface<ifname|vlan>
no passive-interface<ifname|vlan >
Command
Command
Explanation
Enables RIP; the "no router rip" command
disables RIP.
Enables the segment running RIP protocol; the
no network <A.B.C.D/M | ifname|vl an>
command delet es the segment.
Explanation
Specify the IP address of the neighbor router
needs point -transmitting; the no neighbor
<A.B.C.D> command cancels the appointed
router.
Block the RIP broadc ast on specified pot and the
RIP data packet is only transmittable among
Layer 3 switch configured with neighbor. The no
passive-interface<ifname|vlan
cancels the function.
35-3
> command