Planet XGS3-42000R User Manual page 311

and SwitchD make up OSPF area 0,
of layer3 S witchA belongs to area 0), layer3 SwitchD forms OSPF area2 (assume vlan2 interface of layer3
SwitchD belongs to area 0). Swtich1 and SwitchD are backbone layer3 switches, Swtich2 and SwitchD are
area edge layer3 switches, and Switch3 is the in-area layer3 switch.
E1/2 :2010:1:1 ::1/64
vlan1
E1/1 : 2010:1:1 ::2/64
vlan1
SwitchB
E1/2 : 2020:1:1 ::1/64
vlan3
The configuration for lay er3 S witchA and SwitchE is shown below:
Layer3 SwitchA:
Enable OSPFv3 protocol, configure router ID
SwitchA(config)#router IP v6 ospf
SwitchA (config-router)#router-id 192.168.2.1
Configure interface vlan1 IP v6 address and affiliat ed OSPFv3 area
SwitchA#config
SwitchA(config)# interface vlan 1
SwitchA(config-if-vlan1)# IP v6 address 2010: 1:1::1/64
SwitchA(config-if-vlan1)# IP v6 router ospf area 0
SwitchA(config-if-vlan1)#exit
Configure interface vlan2 IP address and affiliated OSPFv3 area
SwitchA(config)# interface vlan 2
SwitchA(config-if-vlan2)# IP v6 address 2100: 1:1::1/64
SwitchA(config-if-vlan2)# IP v6 router ospf area 0
SwitchA (config-if-vlan2)#exit
SwitchA(config)#exit
SwitchA#
layer3 Switch2 and Switch3 form OSPF area 1 (assume vlan1 interface
SwitchA
E1/1 :2100:1:1 ::1/64
vlan2
Area 1
E1/1 : 2020:1:1 ::2/64
Figure 38-3-1 Network topology of OSPF autonomous system
Area 0
E1/1 :2100:1:1 ::2/64
vlan2
SwitchC
vlan3
38-8
SwitchE
SWITCHD
E1/2 :2030:1:1 ::1
vlan3
E1/1 : 2030:1:1 ::2/64
vlan3
SwitchD
Area 2