Planet XGS3-42000R User Manual page 417

ipv6 mroute
<X:X::X:X> <ifname> <.ifname>
no ipv6 mroute
<X:X::X:X> [<ifname> <.ifname>]
3. Configure the additional parameters for PIM-SM
（1）Configure parameters for PIM-SM interfaces
1) Configure the interval for PIM-SM hello messages
Interface Configuration Mode
ipv6 pim hello-interval <interval>
no ipv6 pim hello-interval
2) Configure the hold time for PIM-SM6 hello messages
Interface Configuration Mode
ipv6 pim hello-holdtime <value>
no ipv6 pim hello-holdtime
3) Configure A CL for PIM-SM6 neighbors
Interface Configuration Mode
ipv6 pim neighbor-filter
<acess-li st-name>
no ipv6 pim neighbor-filter
<acess-li st-name>
4) Configure the interfac e as the boundary interface of the PIM-SM6 protocol
Interface Configuration Mode
ipv6 pim bsr-border
no ipv6 pim bsr-border
5) Configure the interfac e as the management boundary of the PIM-SM6 protocol
<X:X::X:X>
<X:X::X:X>
Command
Command
Command
Command
Command
To configure a static multicast routing entry. The
no form of this command will remove the
specified static multicast routing entry.
Explanation
To configure the interval for PIM-SM hello
messages. The no form of this command
restores the interval to the default value.
Explanation
To configure the value of the holdtime field in the
PIM-SM hello messages. The no form of this
command will restore the hold time to the default
value.
Explanation
To configure ACL to filter PIM-SM6 neighbor. If
session to the neighbor has been denied by
ACL, then the sessions that have been set up
will be discarded immediately and new sessions
will not be set up.
Explanation
To configure the interface as the boundary of
PIM-SM6 protoc ol. On the boundary interface,
BSR messages will not be sent or received. The
network connected the interface is considered
as directly connected network. The no form of
this command will remove the configuration.
Explanation
44-8