Planet XGS3-42000R User Manual page 125

Example: As shown in the figure, ports 1, 2, 3, 4 of SwitchA are access ports that belong to VLAN1. Add those
four ports to group1 in "on" mode. Ports 6, 8, 9, 10 of SwitchB are access ports that also belong to VLAN1,
add these four ports to group2 in "on" mode.
The configuration steps are listed below:
SwitchA#config
SwitchA (config)#int erface ethernet 1/1
SwitchA (Config-If-Ethernet1/1)#port-group 1 mode on
SwitchA (Config-If-Ethernet1/1)#exit
SwitchA (config)#int erface ethernet 1/2
SwitchA (Config-If-Ethernet1/2)#port-group 1 mode on
SwitchA (Config-If-Ethernet1/2)#exit
SwitchA (config)#int erface ethernet 1/3
SwitchA (Config-If-Ethernet1/3)#port-group 1 mode on
SwitchA (Config-If-Ethernet1/3)#exit
SwitchA (config)#int erface ethernet 1/4
SwitchA (Config-If-Ethernet1/4)#port-group 1 mode on
SwitchA (Config-If-Ethernet1/4)#exit
SwitchB#config
SwitchB (config)#port-group 2
SwitchB (config)#interface ethernet 1/6
SwitchB (Config-If-Ethernet1/6)#port-group 2 mode on
SwitchB (Config-If-Ethernet1/6)#exit
SwitchB (config)#interface ethernet 1/8-10
SwitchB (Config-If-P ort-Range)#port-group 2 mode on
SwitchB (Config-If-P ort-Range)#exit
Figure 12-4-2 Configuring Port Channel in ON mode
12-6
SwitchA
SwitchB