Anycast Rp V6 Troubleshooting; Pim-Ssm6; Introduction To Pim-Ssm6 - Planet XGS3-42000R User Manual

XGS 3-42000R(config)#ipv6 pim anycast-rp 2006::1 2004::2
RP2 Configuration:
XGS 3-42000R#config
XGS 3-42000R(config)#interface loopback 1
XGS 3-42000R(config-if-Loopback1)#ipv6 address 2006::1/128
XGS 3-42000R(config-if-Loopback1)#exit
XGS 3-42000R(config)#ipv6 pim rp-candidate loopback1
XGS 3-42000R(config)#ipv6 pim multicast-routing
XGS 3-42000R(config)#ipv6 pim anycast-rp
XGS 3-42000R(config)#ipv6 pim anycast-rp self-rp-address 2004::2
XGS 3-42000R(config)#ipv6 pim anycast-rp 2006::1 2003::1
Please pay attention to that, for promulgating loopback interface router, if use MBGP4+ protocol, then can use
network command; or use RIPng protocol, then can use route command.

44.3.4 ANYCAST RP v6 Troubleshooting

When configuring and using A NYCAS T RP v6 function, the ANY CAS T RP might work abnormally because of
faults in physical connections, configurations or something others. So, the users should pay attention to the
following points:

The physical connections should be guaranteed to be correct

The PIM-SM6 protocol should be guaranteed to operate normally

The ANY CAS T RP should be guaranteed to be enabled in Global configuration mode

The self-rp-address should be guarant eed to be configured correctly in Global configuration mode

The other-rp-address should be guaranteed to be configured correctly in Global configuration mode

All the interface routers should be guaranteed to be correctly added, including the loopback interface as
a RP

Use "show ipv6 pim anycast rp status" command to check whether the configuration information of
ANYCAS T RP is correct
If the problems of ANYCAS T still cannot be solved after checking, please use debug commands like "debug
ipv6 pim anycast-rp", then copy the DEBUG information within three minutes and send it to the technical
service cent er of our company.

44.4 PIM-SSM6

44.4.1 Introduction to PIM-SSM6

Source Specific Multicast (PIM-SSM6) is a new kind of multicast service protocol. With PIM-SSM6, a multicast
session is distinguished by the multicast group address and multicast source address. In SSM6, hosts can be
added int o the multicast group manually and efficiently like the traditional P IM-SM6, but leave out the shared
tree and RP management in P IM-S 6M. In SSM6, SPT tree will be constructed with (S,G). G for the multicast
44-16