ipv6 pim scope-border
<500-599>|<acl_name>
no ipv6 pim scope-border
4. Di sable PIM-DM protocol
Interface Configuration Mode
no ipv6 pim dense-mode
Global Configuration Mode
no ipv6 pim multicast-routing
44.1.3 PIM-DM6 Typical Application
As shown in the following figure, add the Ethernet interfaces of S witch A and Switch B to corresponding vlan,
and start PIM-DM Protocol on each vlan int erface.
The configuration procedure for SwitchA and SwitchB is as below:
(1) Configure SwitchA:
XGS 3-42000R(config)#ipv6 pim multicast-routing
XGS 3-42000R(config)#interface vlan 1
XGS 3-42000R(config-if-Vlan1)#ipv6 address 2000:10:1:1::1/64
XGS 3-42000R(config-if-Vlan1)#ipv6 pim dense-mode
Command
Figure 44-1-1
To configure PIM-DM6 management boundary
for the interface and apply ACL for the
management boundary. With default settings,
ffx0::/13 is considered as the scope of the
management group. If ACL is configured, then
the scope specified by ACL permit command is
the scope of the management group. acl_name
should be standard IP v6 ACL name. The no
form
of
this
configuration.
To disable PIM-DM for the specified interface.
To disable PIM-DM globally.
PIM-DM Typical Environment
44-4
command
will
remove
Note s
the