Pim-Ssm6 Configuration Task List; Pim-Ssm6 Configuration Example - Planet XGS3-42000R User Manual

group address and S for the source address of the multicast which sends datagram to G. (S,G) in a pair is
named as a channel of SSM6. SSM6 serves best for the application of multicast service which is from one
station to many ones, for example, the network sports video channel, and the news channel. By default, the
multicast group address of SSM6 is limited to ff3x::/32. However this address range can be extended
according to actual situations.
PIM-SSM6 can be supported in the PIM-DM6 environment.

44.4.2 PIM-SSM6 Configuration Task List

Global configuration mode
ipv6 pim ssm {default|range <access-li st-number>}
no ipv6 pim ssm

44.4.3 PIM-SSM6 Configuration Example

As it is shown in the below figure, ethernet interfaces of switchA, switchB, switchC, and switchD are
separated into different vlan. And PIM-SM6 or P IM-DM6 is enabled on all the vlan int erfaces. Take
configuration of P IM-SM6 for example.
Configurations of switchA , switchB, switchC and switchD are listed as below:
(1) Configuration of switchA：
Command
Figure 44-4-1 PIM-SSM typical environment
44-17
Explanation
To configure address range for
pim-ssm multicast group. The
no prefix will disable
command.
this