Planet XGS3-42000R User Manual page 363

ip pim
neighbor-filter{<access-li st-number
> }
no ip pim
neighbor-filter{<access-li st-number
> }
4) Configure the interface as the boundary interface of the P IM-SM protocol
Command
Interface Configuration Mode
ip pim bsr-border
no ip pim bsr-border
5) Configure the interface as the management boundary of the PIM-SM protocol
Command
Interface Configuration Mode
ip pim scope-border <1-99 > |
<acl_nam e>
no ip pim scope-border
(2) Configure global PIM-SM parameter
1) Configure the switch as a candidate BSR
Command
Global Configuration Mode
ip pim bsr-candidate {vlan
<vlan-id>|
<ifname>}[ <mask-length> ][ <priorit
y> ]
no ip pim bsr-candidate
To configure ACL to filter PIM-SM neighbors. If
session to the neighbor has been denied by
ACL, then the sessions that have been set up
will be discarded immediately and new sessions
will not be set up.
Explanation
To configure the interface as the boundary of
PIM-SM protoc ol. On the boundary interface,
BSR messages will not be sent or received. The
network connected the interface is considered
as directly connected network. The no form of
this command will remove the configuration.
Explanation
To configure PIM-SM management boundary for
the interface and apply ACL for the management
boundary. With default settings, 239.0.0.0/8 is
considered as the scope of the management
group. If ACL is configured, then the scope
specified by ACL permit command is the scope
of the management group. acl_name should be
standard IP v4 ACL name. The no form of this
command will remove the configuration.
Explanation
This command is the global candidate BS R
configuration command, which is used to
configure the information of PIM-SM candidate
BSR so that it can compete for BSR router with
other candidate BSR.
bsr-candidate" command
configuration of BSR.
43-11
The "no ip pim
cancels the