XGS 3-42000R(ulpp-group-1)#exit
XGS 3-42000R(config)#ulpp group 2
XGS 3-42000R(ulpp-group-2)#protect vlan-reference-instance 2
XGS 3-42000R(ulpp-group-2)#exit
XGS 3-42000R(config)#interface ethernet 1/1
XGS 3-42000R(config-If-Ethernet1/1)#switchport mode trunk
XGS 3-42000R(config-If-Ethernet1/1)#ulpp group 1 master
XGS 3-42000R(config-If-Ethernet1/1)#ulpp group 2 slave
XGS 3-42000R(config-If-Ethernet1/1)#exit
XGS 3-42000R(config)#interface Ethernet 1/2
XGS 3-42000R(config-If-Ethernet1/2)#switchport mode trunk
XGS 3-42000R(config-If-Ethernet1/2)# ulpp group 1 slave
XGS 3-42000R(config-If-Ethernet1/2)# ulpp group 2 master
XGS 3-42000R(config-If-Ethernet1/2)#exit
SwitchB configuration task list:
XGS 3-42000R(config)#interface ethernet 1/1
XGS 3-42000R(config-If-Ethernet1/1)#switchport mode trunk
XGS 3-42000R(config-If-Ethernet1/1)# ulpp flush enable mac
XGS 3-42000R(config-If-Ethernet1/1)# ulpp flush enable arp
SwitchC configuration task list:
XGS 3-42000R(config)#interface ethernet 1/2
XGS 3-42000R(config-If-Ethernet1/2)# switchport mode trunk
XGS 3-42000R(config-If-Ethernet1/2)# ulpp flush enable mac
XGS 3-42000R(config-If-Ethernet1/2)# ulpp flush enable arp
61.4 ULPP Troubleshooting
At present, configuration of more than 2 multi-uplinks is allowed, but it may cause loopback, so is
not recommended.
With the normal configuration, if the broadcast storm happen or the communication along the ring is
broken, please enable the debug of ULP P, copy the debug information of 3 minutes and the
configuration information, send them to our technical service center.
61-7