Planet XGS3-42000R User Manual page 270

5）Configure the split horizon
Interface configuration mode
ip rip split-horizon [poi soned]
no ip rip split-horizon
（3）Configure other RIP protocol parameters
1）Configure RIP routing priority
2）Configure the RIP route capacity limit in route table
3）Configure timer for RIP update, timeout and hold-down
4）Configure RIP UDP rec eiving buffer size
Rout er configuration mode
distance <number> [<A.B.C.D/M> ]
[<access-li st-nam e|access-li st-number
>]
no distance [<A.B.C.D/M> ]
maximum-prefix
<maximum-prefix>[<threshold>]
no maximum-prefix <maximum-prefi x >
no maximum-prefix
timers ba sic <update> <invalid>
<garbage>
no timers ba sic
recv-buffer-size <size>
no recv-buffer-size
3. Configure RIP-I/RIP-II toggling
（1）Configure the RIP version to be used in all ports
RIP configuration mode
version { 1 | 2 }
no version
Command
Command
Command
Explanation
Configure that take the split horizon when the
port sends data packets; poisoned for poison
reverse the no ip rip split-horizon command
cancels the split horizon.
Explanation
Specify the rout e administratively distance of
RIP protocol; the no distance
command restore the default value 120.
Configure the maximum of RIP route; the no
maximum-prefix <maximum-prefi x >
no maximum-prefix command canc els the
limit.
Adjust the update,
collection time, the no timers basi c command
restores the default configuration.
The command configures the UDP receiving
buffer size of the RIP; the no recv-buffer-size
command restores the system default values.
Explanation
Configure the versions of all the RIP data
packets transmitted/received by the Layer 3
switch port sending/receiving the no version
command restores the default configuration,
version 2.
35-6
[<A.B.C.D/M> ]
timeout and garbage