Rip Examples; Typical Rip Examples - Planet XGS3-42000R User Manual

6. Configure redistribution of OSPF routing to RIP
(1) Enable Redistribution of OSPF routing to RIP
Rout er RIP Configuration Mode
redistribute ospf [ <proce ss-id> ] [metric
<value> ] [route-map <word> ]
no redistribute ospf [ <proce ss-id> ]
(2) Di splay and debug the information about configuration of redistribution of OSPF routing to RIP
Admin Mode and Configuration Mode
show ip rip redistribute
Admin Mode
debug rip redistribute message send
no debug rip redistribute message send
debug rip redistribute route receive
no debug rip redistribute route receive

35.3 RIP Examples

35.3.1 Typical RIP Examples

Interface
vlan1:10. 1.1.1/24
SWITCHA
vlan2:20. 1.1.1/24
In the figure shown above, a network consists of three Layer 3 switches, in which S witchA connected with
SwitchB and SwitchC, and RIP routing protocol is running in all of the three s witches. SwitchA （interface
vlan1：10.1.1.1,interface vlan2：20.1.1.1）exchanges Layer 3 switch update messages only with SwitchB
（interfac e vlan1：10.1. 1.2）, but not with SwitchC（interface vlan 2: 20.1. 1.2）.
SwitchA, SwitchB, SwitchC configurations are as follows:
a) Layer 3 SwitchA：
Command
Command
Interface
Figure 35-3-1 RIP example
Explanation
To enable or disable the redistribution
OSPF routing to RIP.
Explanation
To display the information about configuration
of redistribute from other routing.
To enable or disable debugging messages
sent by RIP for redistribution of OSPF routing.
To enable or disable debugging messages
received from NSM.
Interface
vlan1:10. 1.1.2/24
Interface
vlan1:20. 1.1.2/24
35-8
SWITCHB
SWITCHC
of