Typical Applications Of The Dot1Q-Tunnel - Planet XGS3-42000R User Manual

dot1q-tunnel enable
no dot1q-tunnel enable
2. Configure the type of protocol (TPI D) on the ports
Port mode
dot1q-tunnel tpid
{0x8100|0x9100|0x9200|<1-65535>}

14.3.3 Typical Applications of the Dot1q-tunnel

Scenario:
Edge switch PE1 and PE2 of the ISP internet forward the VLAN200~300 data bet ween CE1 and CE2 of the
client network with VLA N3. The port1 of PE1 is connected to CE1, port10 is connected to public network, the
TP ID of the connected equipment is 9100; port1 of PE2 is connected to CE2, port10 is connected to public
network.
Configuration Item
VLAN3
dot1q-tunnel
tpid
Configuration procedure is as follows:
PE1:
XGS 3-42000R(config)#vlan 3
XGS 3-42000R(config-Vlan3)#s witchport interface ethernet 1/1
XGS 3-42000R(config-Vlan3)#exit
XGS 3-42000R(config)#interface ethernet 1/1
XGS 3-42000R(config-Ethernet1/1)# dot1q-tunnel enable
XGS 3-42000R(config-Ethernet1/1)# exit
XGS 3-42000R(config)#interface ethernet 1/10
XGS 3-42000R(config-Ethernet1/10)#s witchport mode trunk
XGS 3-42000R(config-Ethernet1/10)#dot1q-tunnel tpid 0x9100
XGS 3-42000R(config-Ethernet1/10)#exit
XGS 3-42000R(config)#
PE2:
XGS 3-42000R(config)#vlan 3
XGS 3-42000R(config-Vlan3)#s witchport interface ethernet 1/1
XGS 3-42000R(config-Vlan3)#exit
XGS 3-42000R(config)#interface ethernet 1/1
XGS 3-42000R(config-Ethernet1/1)# dot1q-tunnel enable
XGS 3-42000R(config-Ethernet1/1)# exit
XGS 3-42000R(config)#interface ethernet 1/10
XGS 3-42000R(config-Ethernet1/10)#s witchport mode trunk
XGS 3-42000R(config-Ethernet1/10)#dot1q-tunnel tpid 0x9100
Command
Port1 of PE1 and PE2.
Port1 of PE1 and PE2.
9100
Enter/exit the dot1q-t unnel mode on the
ports.
Explanation
Configure the type of protoc ol on TRUNK
port.
Configuration Explanation
14-12