Planet XGS3-42000R User Manual page 358

b) Configure the interval for state-refresh messages
Interface Configuration Mode
ip pim state-refresh
origination-interval
no ip pim state-refresh
origination-interval
c) Configure the boundary interfaces
Interface Configuration Mode
ip pim bsr-border
no ip pim bsr-border
d) Configure the management boundary
Interface Configuration Mode
ip pim scope-border
<1-99 > |<acl_name>
no ip pim scope-border
4. Di sable PIM-DM protocol
Interface Configuration Mode
no ip pim dense-mode
Global Configuration Mode
no ip pim multicast-routing
Command
Command
Command
Command
Explanation
To configure the interval for sending PIM-DM
state-refresh packets. The no form of this
command will restore the default value.
Explanation
To configure the interface as the boundary of
PIM-DM protocol. On the boundary interface,
BSR messages will not be sent or received. The
network connected the interface is considered
as directly connected network. The no form of
this command will remove the configuration.
Explanation
To configure PIM-DM management boundary for
the interface and apply ACL for the management
boundary. With default settings, 239.0.0.0/8 is
considered as the scope of the management
group. If ACL is configured, then the scope
specified by ACL permit command is the scope
of the management group. The no form of this
command will remove the configuration.
Explanation
To disable the PIM-DM protocol for the interface.
To disable PIM-DM globally.
43-6