Table of Contents
Advertisement
If the IP is successfully configured, the Managed Switch will apply the new
IP address setting immediately. You can access the Web interface of Managed
Switch through the new IP address.
If you are not familiar with console command or the related
parameter, enter "help" anytime in console to get the help
description.
4.3 Setting 1000BASE-X for 10G SFP+ Port
The Managed Switch supports both 1000BASE-X and 10GBASE-X SFP
transceivers by manual setting and the default SFP+ port speed is set in the
fiber auto mode, so the end-user can plug the transceiver directly.
In another example, the end-user has to force the fiber connection with
1000BASE-X SFP transceiver in the ethernet 1/0/1. The following command
configuration is required:
Switch#config
Switch(config)#interface ethernet 1/0/1
Switch(config-if-ethernet1/0/1)#media-type fiber-1g
4.4 Saving the Configuration
In Managed Switch, the running configuration file stores in the RAM. In the
current version, the running configuration sequence running-config can
be saved from the RAM to FLASH by write command, so that the running
configuration sequence becomes the start-up configuration file, which is called
configuration save.
Switch#write
Confirm to overwrite current startup-config configuration [Y/N]:y
Write running-config to current startup-config successful
Switch#%May 22 00:02:57.730 2023 Write configuration successfully!
10
Figure 4-6 Setting 1000BASE-FX Screen
Figure 4-7 Write Screen
Advertisement
Table of Contents
