Port Isolation Function Typical Examples - Planet XGS3-42000R User Manual

4. Di splay the configuration of port i solation
Admin Mode and global Mode
show isolate-port group [ <WORD> ]

8.3 Port Isolation Function Typical Examples

The topology and configuration of s witches are showed in the figure above, with e1/1, e1/10 and e1/15 all
belonging to V LAN 100. The requirement is that, aft er port isolation is enabled on switch S1, e1/1 and e1/10
on switch S1 can not communicate with each other, while bot h of them can communicate with the uplink port
e1/15. That is, the communication bet ween any pair of downlink ports is disabled while that bet ween any
downlink port and a specified uplink port is normal. The uplink port can communicate with any port normally.
The configuration of S1:
XGS 3-42000R(config)#isolate-port group test
XGS 3-42000R(config)#isolate-port group test switchport interface et hernet 1/1;1/10
Command
Vlan
e1/1
S2
Figure 8-3-1 A typical example of port isolation function
Explanation
Display the configuration of port isolation,
including all configured port isolation groups
and Ethernet ports in each group.
e1/15
S1
e1/10
8-2
S3