Vlan-Translation Configuration; Introduction To Vlan-Translation - Planet XGS3-42000R User Manual

XGS 3-42000R(config-Ethernet1/10)#exit
XGS 3-42000R(config)#

14.4 VLAN-translation Configuration

14.4.1 Introduction to VLAN-translation

VLAN translation, as one can tell from the name, which translates the original VLAN ID to new VLAN ID
according to the user requirements so to exchange data across different VLANs. The VLAN translation is
classified to ingress translation and egress translation, res pectively translation the VLA N ID at the ent rance or
exit.
Application and configuration of VLA N translation will be explained in detail in this section.
14.4.2 VLAN-translation Configuration
Configuration task sequence of VLAN-translation:
1. Configure the VLA N-translation function on the port
2. Configure the VLA N-translation relations on the port
3. Configure the VLA N-translation packet dropped on port if there is any failure
1. Configure the VLAN-translation of the port
Port mode
vlan-translation enable
no vlan-translation enable
2. Configure the VLAN-translation relation of the port
Port mode
vlan-translation <old-vlan-id> to
<new-vlan-id> {in|out}
no vlan-translation old-vlan-id {in|out}
3. Configure the VLAN-translation relation, check if there is any failure or packet dropped
Port mode
vlan-translation miss drop {in|out|both}
no vlan-translation miss drop {in|out|both}
Command
Command
Command
Explanation
Enter/exit the port VLAN-translation
mode.
Explanation
Add/delete a VLAN-translation relation.
Explanation
Configure the VLA N-translation packet
dropped on port if there is any failure.
14-13