Planet XGS3-42000R User Manual page 107

1．Configure the time interval of loopback detection
Global Mode
loopback-detection interval-time
<loopback> <no-loopback>
no loopback-detection interval-time
2．Enable the function of port loopback detection
Port Mode
loopback-detection specified-vlan
<vlan-list>
no loopback-detection specified-vlan
<vlan-list>
3．Configure the control method of port loopback detection
Port Mode
loopback-detection control {shutdown
|block| learning}
no loopback-detection control
4．Di splay and debug the relevant information of port loopback detection
Admin Mode
debug loopback-detection
no debug loopback-detection
show loopback-detection [interface
<interface-li st>]
5. Configure the loopback-detection control mode (automatic recovery enabled or not)
Global Mode
loopback-detection control -recovery
timeout <0-3600>
Command
Command
Command
Command
Command
Explanation
Configure the time interval of loopback
detection.
Explanation
Enable and disable the function of port
loopback detection.
Explanation
Enable and disable the function of port
loopback detection cont rol.
Explanation
Enable the debug information of the
function module of port loopback detection.
The no operation of this command will
disable the debug information.
Display the state and result of the loopback
detection of all ports, if no parameter is
provided; otherwis e, display the state and
result of the corresponding ports.
Explanation
Configure the loopback-det ection control
mode (automatic recovery enabled or not )
or rec overy time.
9-4